433mhz 500mw telemetry

This is 3Drobotics 433Mhz V1 500Mw Telemetry Kit From The category RC Drone Accessories for Flight Controller. You can connect a flight controller to a USB or UART-equipped device, such as a computer, laptop, or tablet supporting a USB connection, using this 3DR Radio Telemetry 433MHz 500mW Set (OTG).

Specifications:

• Status documents for the MAVLink protocol
• Spread Spectrum and frequency modulation (FHSS)
• Adaptation by oneself to time division multiplexing
• Encourage LBT and AFA
• adjustable duty cycle
• Error-correcting code built-in (up to 25% data bit error)
• Configure data transport using AT commands
• remote control data transmission with the RT command
• movable 433MHz air and ground modules
• USB 2.0 port
• maximum output power of 250mW from a 6-position Molex connector (adjustable)
• 2-way full-duplex communication over an adaptive TDM UART interface using a SMA connector
• a clear serial link
• downloadable SIK firmware
• Through the use of *Mission Planner and *APM Planner, configure
• With a Si1000 8051 microprocessor and a Si4432, based on the HM-TRP wireless module