Turnigy have recognized the Mobius ActionCam as the go-to camera for the RC hobby and set out to make a low cost, light weight, quality component 2-Axis gimbal to match the Mobius’s smaller size.
The Turnigy Mobius gimbal started with the popular AX 2206 BLGM, perfect for its small size and being well known as a great motor. From there Turnigy had the motors custom made to match their spec. The Turnigy Mobius gimbal looked to one of the leaders in gimbals for their robust controller and easy GUI interface, settling on the Tarot 2 axis BGC as the heart of the Mobius gimbal and includes the USB programmer for future updates and configuration. Turnigy then set out to create a lightweight and robust frame around the Mobius and chosen hardware. The result is the one of best gimbals available and best of all it’s made specifically for the Mobius.
• Light Weight
• AX2206 Gimbal motors
• Tarot BGC and IMU for control
• Stick and Rate mode for roll and pitch control
• RC roll and pitch control
• ALL CNC Aluminum and composite frame
• Included USB programming tool
* Note: Please pay close attention to the bolt locations in the instructions, and note the pitch motor uses the 2 M6 bolts, if the M8 bolts are used could damage the motor windings causing the pitch axis to shake when powered.
Size: HxWxL 76x67x100mm max all around size
Motor Specs AX2206:
Bottom holes center to center: 16mm and 19mm
Top holes center to center: 12mm
Tarot ZTX22 Specs:
Working Voltage: DC 7.4V ~ 14.8V (Recommended 12V, three lithium battery)
Working current: 200mA-500mA (power supply voltage and the motor related)
Working temperature: -15c ~ 65c
Processor: Dual 32-bit high-speed ARM core processor
Sensor: Three rotor MEMS gyroscope rotor MEMS accelerometers
Maximum angular rate: 2000 ° / sec
Maximum acceleration: 16g
Control frequency: 2000Hz
Motor drive frequency: 20KHz (no noise smoothing drive)
Control accuracy: 0.1 degControl angle range: -45 ° ~ 45 ° (roll), -135 ° ~ 90 ° (tilt)
Power Interface: DC 7.4V ~ 14.8V (Recommended 12V, three lithium battery)
Note: This is a Kit and does require some assembly and a Windows based computer to flash the Tarot configuration with the included USB tool.